AIRFLOW 1 600 ml, pneumatic applicator for 600 ml sachets, dome plunger, for thicker materials, 8.5 bar 125 psi regulator version, approx. 1.70 kN thrust

AIRFLOW 1 600 ml is a pneumatic applicator for 600 ml sachets designed for dispensing thicker materials using compressed air. The 8.5 bar (125 psi) regulator version helps deliver a stable output and good control of dispensing speed, supporting a consistent bead and improved repeatability. A dome plunger supports even sachet compression and more controlled dispensing.

Advantages and unique features

• 8.5 bar (125 psi) regulator version – recommended for thicker materials and more demanding dispensing.
• High-flow trigger valve for fast start of material output.
• Quick exhaust valve to minimise “flow-on” after releasing the trigger.
• Integral pressure regulator to control dispensing speed and flow stability.
• Dome plunger to support even sachet compression and more precise output.
• Reduced hand fatigue vs. manual dispensing during longer jobs.

Properties and applications

• Intended use: dispensing single-component materials from 600 ml sachets with compressed air.
• Applications: production and service work where repeatability and faster dispensing of thicker compounds are required.
• Output control: pressure adjustment helps match flow rate to viscosity and the required bead size.
• Operational note: use clean, dry air and ensure adequate compressor flow for stable performance.

Technical parameters

Storage recommendations

Store the tool in a dry area and protect it from contamination that could affect valve performance. Use clean, dry compressed air. For intensive use, ensure stable compressor flow and sufficient receiver capacity to minimise pressure fluctuations.

FAQ

1) Which packaging does this applicator support?
600 ml sachets.

2) Why is this version better for thicker materials?
It uses the 8.5 bar (125 psi) regulator version, which helps maintain stable output under higher material resistance.

3) Does it reduce “flow-on” after release?
Yes. A quick exhaust valve helps minimise flow-on after releasing the trigger.

4) How can I improve dispensing consistency?
Set a stable pressure on the regulator, use clean/dry air, and keep a consistent nozzle angle and travel speed.