HDPE S15 Cartridge Cap for Sealing After Use, No Clip, 0.9 g

S15 Cartridge Cap (Melkib Cartridge cap) is a lightweight screw-on cap made from HDPE, designed to seal cartridges or foil bag systems after use. According to the manufacturer, replacement screw caps help prevent the cartridge or foil-bag content from drying out, extending usability and allowing re-application on following days. The cap fits standard S15 threaded components.

Benefits and unique features

• Designed to seal cartridges or foil bag systems after use.
• Helps reduce drying of the content (per manufacturer description).
• Can support re-application on following days by extending usability (per manufacturer information).
• S15 thread – compatible with standard S15 threaded components.
• No clip fixation variant.
• Very lightweight: 0.9 g.

Properties and applications

• After-use sealing: for closing cartridges and foil-bag systems when the job is finished.
• Anti-drying support: reduces air contact which may lower the risk of drying (per manufacturer description).
• S15 thread: for use on standard S15 threaded components.
• Practical use: especially where materials can skin over after a pause; suitability depends on the compound and storage conditions.

Technical parameters

Storage recommendations

Store the caps in a clean and dry area, preferably in the original packaging, away from direct UV exposure and heat sources. After use, screw the cap onto a clean S15 thread; if there is residue on the thread, remove it to improve sealing for the next use.

FAQ

1) What is the S15 cartridge cap used for?
It is used to close cartridges or foil-bag systems after use to help reduce drying of the content.

2) Does it fit the S15 standard?
Yes – per manufacturer information, S15 threads can be used on standard S15 threaded components.

3) Can the cap help extend material usability?
According to the manufacturer, it helps prevent drying after use, which can extend usability and support re-application on following days.

4) How should I use it after finishing a job?
Screw it onto a clean S15 thread; remove any residue from the thread to improve sealing.