KONTAKT PCC 400 ml – PCB Cleaner and Flux Remover
Product code: 1038459
Leave feedback on the product
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Secure purchase guarantee
Opis produktu
KONTAKT PCC is an aerosol cleaner for printed circuit boards and flux removal. It contains a special blend of organic solvents and is free from CFCs and HCFCs. An additional brush spray head is included.
The product dries quickly on the surface without leaving residues. It can be used for cleaning before and after soldering and repair work.
APPLICATION
For cleaning printed circuit boards and other electronic components, including before the application of conformal coatings or protective stickers.
BENEFITS
- High cleaning efficiency thanks to its special solvent blend.
- Fast surface drying without leaving residues.
- The brush spray head supports effective, fast mechanical cleaning.
- Compatible with markings and colour codes.
- Helps provide clean printed circuit boards, a high level of surface resistance, reduced leakage currents and good adhesion of conformal coatings.
TECHNICAL DATA
| Parameter | Value |
|---|---|
| Appearance | Clear, colourless liquid |
| Odour | Mild |
| Density at 20°C | 0.8 g/cm³ |
| Flash point | < 0°C |
| Evaporation rate (ether = 1) | 10 |
| Packaging | Aerosol, 400 ml |
| Propellant and fill | Carbon dioxide propellant enables the can to be filled with approximately 95% active product. |
INSTRUCTIONS
- The brush spray head supports mechanical cleaning. The 360° valve allows the aerosol to be used upside down, particularly in hard-to-reach areas.
- For minor cleaning, rinsing the printed circuit board with KONTAKT PCC is sufficient. Brushing improves cleaning efficiency.
- To remove flux residues, first wet the brush, then spray the product while brushing and applying gentle pressure to the printed circuit board.
- Hold the board as vertically as possible and work from top to bottom. For optimum results, rinse the surface again with KONTAKT PCC.
LIMITATIONS AND SAFETY
- The product has been tested for compatibility with PCB materials, solder resist and electronic components. It does not damage colour markings.
- Some plastics, particularly polystyrene and polycarbonate, may be damaged. Test compatibility with these materials beforehand.
- Because the product contains flammable solvents, remove all sources of ignition.
- Do not spray onto equipment that is energised.
Reviews
If you've added a review and it doesn't appear on the list, it may be pending moderation.
Leave feedback on the product
