Medmix MCH 10-24T C-System static mixer for 2K adhesives, bell cup connection, 24 elements, 10 mm, 277 mm, 1:1 and 2:1 mix ratios

The Medmix MCH 10-24T is a professional C-System static mixer nozzle for 2K adhesives. Its bell cup connection and 24 mixing elements ensure uniform blending of the components at 1:1 and 2:1 mix ratios, while the stepped tip with a 10 mm outlet enables precise bead application.

Advantages and unique features

• C-System bell connection – compatible with 2K cartridges featuring a Kelch cup interface.
• Mixes adhesives at two ratios, 1:1 and 2:1, with a single mixer type.
• Twenty-four mixing elements guarantee homogeneous mixing of components A and B.
• 10 mm outlet diameter – optimal for bead application on structural joints.
• Overall length of approx. 277 mm provides stable flow even with higher-viscosity adhesives.
• Stepped tip allows trimming to adjust flow rate and bead width.

Properties and applications

• Accurate 2K mixing: the nozzle ensures the correct component ratio, resulting in full strength and performance of the adhesive.
• Bead application: ideal for linear dispensing along edges, grooves, lap and butt joints.
• C-System – cup connection: compatible with two-component cartridges using the industrial bell connection standard.
• Stepped outlet: the outlet can be shortened step by step to increase flow or tailor bead width to the task.
• Typical industries: automotive, mechanical engineering, composite manufacturing, metal and panel assembly.

Technical data

Storage recommendations

Store Medmix MCH 10-24T mixers in their original packaging in a dry, clean environment, away from direct sunlight and heat sources. Protect the mixers from crushing and from damage to the bell connection. Keep out of the reach of children and use only with compatible 2K cartridges according to the adhesive manufacturer’s instructions.

FAQ

1) Which cartridges are compatible with the Medmix MCH 10-24T nozzle?
The mixer is designed for two-component cartridges with a C-System (cup) connection operating at 1:1 or 2:1 mix ratios.

2) Is the MCH 10-24T mixer reusable?
No, it is a single-use mixer. Once the adhesive has cured inside the mixing channel, a new nozzle must be installed.

3) Can the adhesive bead width be adjusted?
Yes, the stepped outlet tip can be trimmed to adjust bead width and flow rate to the specific application.

4) What applications is this mixer best suited for?
MCH 10-24T is optimised for bead application when bonding structural parts, panels and profiles, and for general industrial assembly.