Teroson RB R2000 HS BK 1 l black coating based on rubber and resin, can be varnished, maintains and fills defects in coatings for chassis, for spot repairs, can be varnished, abrasion resistant

Price: €13.27 13.27
Net price: €10.79
quantity szt.
You gain 6 points [?]
add to wish list


Solvent-based chassis compound based on rubber resin. Does not contain bitumen. After drying, it forms a corrosion-resistant, permanently elastic and abrasion-resistant layer with high aging resistance, which does not lose its elasticity even at low temperatures. The dried weight adheres well to the cleaned chassis surfaces, including painted and PVC. Painting the dried material is possible if the varnish is applied in two thin layers.


TEROSON RB R2000 is used as an anti-corrosion agent for new components or to improve the existing protection of the chassis surface: wheel arches, flat chassis parts on the sills, front and rear aprons, spoilers, especially as stone chips. The material adheres well to primed or painted surfaces. TEROSON RB R2000 is also recommended for soundproofing car bodies by mounting in wheel arches and sidewalls. It can also be used to cover and seal repaired areas, welds and overlap connections.

Surface preparation

Protected surfaces must be dry, free from dust, grease and sand and other elements that reduce adhesion. Rust must be removed. Preferably with a wire brush or sandper. Protective wax must be removed from new vehicles. Pay attention to corroded areas on old cars. Surfaces not coated with TEROSON RB R2000 should be covered with protective paper.


The UBS pistol is needed for application. The air pressure for applying the mass should be 4-5 bar. Mix the contents of the can thoroughly, shaking before use. Do not leave the used container uncovered, as a hard, dry crust will form on the surface of the material. TEROSON RB R2000 can be applied wet up to a thickness of 1.5 mm on vertical surfaces. To avoid spray shadows, it is necessary to spray in two directions - across. After application, the vehicle can be used after 2-4 hours under favorable weather conditions. Full curing of the material takes from 24 to 48 hours. For cleaning uncured material, we recommend FL Remover.


•Risk of freezing: no
•Recommended storage temperature: 10 to 20 °C
•Storage time: 12 months in original packaging


•Colour: white, black, grey
•Odour: petrol
•Consistency: thick liquid
•Specific gravity: approx. 0.97 g/cm3
•Solids content: ca 60%
•Stability: good
•Wet layer thickness: 1.5 mm
•Drying out: 2-4 hours
•Through drying: 24-48 hours
•Application temperature: 10°C to 25°C
•Application temperature: -25°C to 80°C (short-term up to 1 h): 100°C
•Abrasion resistance: very high

Shipping costs The price does not include any possible payment costs

Shipping country:

Product reviews (0)

Files to download

Shop is in view mode
View full version of the site
Sklep internetowy Shoper Premium