MOLYKOTE D-7409 500 g, heat-curing dry-film lubricant, oil/solvent-resistant, −70–300 °C, 5–20 µm
Product code: 1503016
Leave feedback on the product
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
Related products
Secure purchase guarantee
Product description
MOLYKOTE D-7409 Anti-Friction Coating 500 g is a heat-curing dry-film lubricant for metal. It combines excellent lubrication with corrosion protection, high wear resistance and high-temperature performance, especially where conventional oils and greases cannot be used.
Benefits and unique features
- Strong anti-wear and anti-corrosion performance; high load-carrying capacity
- Resistance to oils, greases and solvents
- Service temperature range: −70 to +300 °C
- Effective under slow/oscillating motion and intermittent duty; reduces fretting corrosion
- Enables permanent lubrication where fluid lubricants are unsuitable
Properties and applications
- Typical uses: piston rings and tappets, starter motor armatures, bonnet/hood lock parts, highly stressed sliding areas with low speeds and oscillating movements.
- Surface prep: clean and degrease thoroughly; phosphating or ~180-grit blasting is recommended to improve adhesion and service life.
- Application: spray (3–5 bar), dip, spin, or brush; target 5–20 µm dry film.
- Curing: typically 30 min at 220 °C (part temperature); brief flash-off before oven.
- Coverage & thinner: ~16 m2/kg at 10 µm; recommended thinner – MOLYKOTE 7415 Thinner.
Technical parameters
| Parameter | Value |
|---|---|
| Type | heat-curing dry-film lubricant |
| Colour | grey-black |
| Service temperature | −70 °C to +300 °C |
| Dynamic viscosity (23 °C) | ~400 mPa·s |
| Density (23 °C) | ~1.17 g/ml |
| Flash point | ~35 °C (Tag CC) |
| Recommended DFT | 5–20 µm |
| Coverage | ~16 m2/kg at 10 µm |
| Curing schedule | 30 min / 220 °C (part temperature) |
| Shelf life / storage | up to 36 months sealed at 5–23 °C |
| Thinner | MOLYKOTE 7415 Thinner |
| Pack size | 500 g |
Storage recommendations
Store in the original tightly closed container in a dry, well-ventilated area, ideally at 5–23 °C (max 40 °C). Keep away from ignition sources; vapours may form explosive mixtures with air. Ground equipment during transfer.
FAQ
1) Media resistance?
Cured film resists oils, greases and solvents.
2) Surface preparation?
Degrease; for best adhesion use phosphating or ~180-grit blasting.
3) Film thickness?
Typically 5–20 µm dry.
4) Curing profile?
30 min at 220 °C (part temperature).
5) Storage?
Sealed 5–23 °C (up to 36 months); keep away from flames, general 0–40 °C acceptable.
Product safety
Manufacturer
UNIVAR Poland Sp. z o.o.
Sławęcińska 14
05-850 Ożarów Mazowiecki, Poland
Responsible person in the EU
UNIVAR Poland Sp. z o.o.
Sławęcińska 14
05-850 Ożarów Mazowiecki, Poland
Reviews
If you've added a review and it doesn't appear on the list, it may be pending moderation.
Leave feedback on the product
Log in with Google
