CYBERBOND CB 5600 50G LOW ODOUR CYANOACRYLATE ADHESIVE HIGH VISCOSITY LOW BLOOMING H B FULLER

CYBERBOND CB 5600 50G low odour cyanoacrylate with reduced blooming

CYBERBOND CB 5600 is a one component LOW ODOUR cyanoacrylate adhesive based on an alkoxyester formulation. It is selected when you want a fast CA bond while helping to reduce blooming (white residue around the bond line) and outgassing. Manufacturer: H.B. FULLER. Product code: 15045079.

Pack size: 50G for maintenance and service work. We also stock a 500G version for production and dosing.

When CB 5600 is a good fit

✅ low odour CA for workshop and maintenance areas

✅ reduced blooming when bond appearance matters

✅ high viscosity for better control and less running

✅ fast bonding for quick assembly steps

Typical applications

CB 5600 is commonly used for fast bonding in maintenance repair and light production, especially when the joint is visible or the process benefits from reduced blooming.

Examples of substrates referenced in technical data: steel, EPDM, ABS.

How to use for repeatable results

1) Surface preparation: clean, degrease and dry the parts. This is the most common reason for poor bonding results.

2) Apply sparingly: CA adhesives perform best in thin bond lines. Use a small drop and assemble immediately.

3) Hold in position: keep contact pressure until initial set is reached. Set time depends on substrate and conditions.

4) If the process needs it: use an activator to speed up cure or improve repeatability in difficult conditions.

Technical parameters

Storage

Store in a cool and dark place in the original tightly closed container. Before use, allow the product to reach room temperature to maintain consistent performance.

Recommended add ons for a reliable process

If you want faster set or improved repeatability, consider an activator. For difficult to bond plastics like PP PE POM, a primer is typically required.

[product id="4938,4946"]

Browse the full category: Cyanoacrylate adhesives.

FAQ

What does blooming mean in CA bonding

Blooming is a white residue that can appear around the bond line. It depends on the process conditions such as dosage, ventilation, humidity and substrate. CB 5600 is designed to help reduce blooming, but correct application still matters.

Can I bond PP or PE with this adhesive

PP and PE usually require a primer. Use a suitable primer before bonding to improve adhesion on these plastics.

How can I speed up bonding

An activator is commonly used to speed up set time and improve repeatability in less favourable conditions.

Which size should I choose 50G or 500G

Choose 50G for maintenance, service and smaller consumption. Choose 500G for production use and dosing where consistent application and economy matter.