46 / 5 000 Wyniki tłumaczenia Tensorgrip L27 contact adhesive for spraying 22l

Tensorgrip L27 high-temperature-resistant contact adhesive spray

TensorGrip L27 is a high-performance contact adhesive. It creates strong and durable bonds between decorative surfaces and common wood-based materials. It is designed for bonding HPL, carbon fibre, edging, foams, fabrics, carpets, cork and rough plastics. NOT RECOMMENDED for bonding plasticised PVC, flexible plastics, PP, PE and polystyrene.

Advantages

• High solids content.
• Easy application control.
• Versatile.
• Economical.

Applications

• Plywood
• Standard laminates
• Wood-to-wood bonding
• Fibre-reinforced laminates
• Concrete

Technical data

Chemical technical data

Application

Handling and storage

• Read the safety data sheet before use.
• Do not store at temperatures above 50°C.
• Avoid exposure to direct sunlight.
• For maximum performance, use the adhesive at a temperature of 18°C, but always above 10°C.
• Do not store directly on a concrete floor.
• Condition the substrates at normal room temperature of 18°C for 48 hours before bonding.
• Do not exceed the adhesive open time.
• It is recommended to test the product to determine its suitability for the intended application before using it in production.

Instructions for use

• The product has been designed to be sprayed onto two surfaces to bond them together. For the best results, the temperature of the adhesive and the bonded materials should be between 16°C and 27°C.
• Use in adequately ventilated areas. We recommend shaking the container thoroughly before use.
• Before use, check compatibility by spraying a small test amount of adhesive onto the surface. This product may degrade some substrates.

1. Ensure that the surfaces to be bonded are dry, clean and free from dust, grease, wax, paint residues, lubricant and other contaminants.
2. Spray from a distance of 10–20 cm at a 90° angle to the substrate until a uniform and even adhesive layer covering 80 to 100% of the bonded surfaces is obtained. If necessary, spray another layer of adhesive in areas where coverage is insufficient.
3. Apply the adhesive to both surfaces being bonded. Spray one surface vertically and the other horizontally.
4. Wait 1–3 minutes for the solvent to evaporate. The time may vary depending on the thickness of the adhesive coating and external conditions such as temperature and humidity.
5. Join the components and press them together. The greater the pressure applied, the higher the bond strength. We therefore recommend using a roller to obtain even and firm pressure. The bond reaches its final strength after 24 hours.

Container replacement and storage

Set the container valve to the off position, spray out the adhesive remaining in the hose and disconnect the spray hose and gun from the container. Connect the spray hose to a container of clean solvent, sold separately, and spray until the liquid runs clear, indicating that the hose and gun have been cleaned. When leaving the hose and spray gun connected to the container, open the container valve. Do not disconnect the hose or gun from the container. Close and lock the spray gun.